Slip 2000 Gas Piston Parts & Choke Tube Cleaner - 32 oz

Slip 2000 Gas Piston Parts & Choke Tube Cleaner - 32 oz

Designed for cleaning shotguns. Removes carbon and plastic wad fouling from barrels and choke tubes.

Slip 2000 Choke Tube Cleaner was designed with your health and safety in mind. Unlike other products, this product is non-flammable, non-hazardous and it is biodegradable. Choke Tube Cleaner provides you with a safe effective way to clean carbon and plastic wad fouling from choke tubes and all those Semi automatic shotguns gas system parts.

Simple to use

For best results, on parts that are not cleaned on regular bases, completely submerse parts to be cleaned and allow to soak for 5 to 15 minutes. Remove parts and wipe, brush or rinse clean. It's that easy. Depending on the frequency of cleaning or type of ammo used a second soaking may be required. You may also push a brush or mop lightly through choke tubes and watch the plastic roll out in sheets.

For larger parts that will not fit into jar, soak a nylon brush or rag in CTC, apply to area that needs to be cleaned and allow product to set for 2 to 5 minutes. When ready to clean, saturate brush or rag with CTC again and wipe or brush away carbon. Parts may also be rinsed clean under hot water.

After cleaning, always apply a Slip 2000 Lubricant to metal surfaces and allow to penetrate pores of metal. Slip 2000 will form a barrier and help keep carbon, lead and plastic from sticking. Your next cleaning will take half the time.

Other uses

Shotguns - Pistols - Revolvers - Black powder guns - Automatic weapons

May be used in chambers and barrels as a bore cleaner. Apply to cylinder faces, bolt faces and any other hard to clean areas and allow to soak for 2 to 10 minutes. Carbon, lead, plastic and powder fouling will wipe clean with a nylon brush. If you use a Slip 2000 Lubricant your next cleaning will be much easier. Users will actually be able to wipe carbon and plastic wad fouling away without cleaning even after a few hundred rounds.

For best results on parts that are not cleaned on regular bases, completely submerse parts to be cleaned in Choke Tube Cleaner and allow to soak for 5 to 15 minutes. Remove parts and wipe, brush or rinse clean.

Warning

Choke Tube Cleaner removes all oil protection from the metal. Make sure parts are completely covered in product if long term soaking is required. Depending on metal composition makeup, larger parts that are left partially above water surface and exposed to the air may rust.